桂林市城区大气VOCs污染特征及对O3和SOA的生成潜势

对桂林市城区大气中挥发性有机物(VOCs)的污染特征,以及VOCs对臭氧(O3)和二次有机气溶胶(SOA)的生成潜势进行了研究。结果显示,研究期间,共检出VOCs物种78种,平均体积分数为21.32×10-9,表现为芳香烃(67.82%)烷烃(19.56%)卤代烃(7.50%)烯烃(2.86%)含氧挥发性有机物(1.41%)。VOCs体积分数空间分布呈现市中心和下风向郊区两个高值区。通过苯与甲苯的浓度比值发现,林科所VOCs主要来自交通源和生物源,师专甲山校区VOCs主要是来自交通源,其余测点VOCs主要来自交通源、工业源和外来传输源。分析乙苯和间/对二甲苯的浓度比值发现,电子科大尧山校区气团光化学年龄较大,光化学反应活性相对较强烈;旅游学院、华侨旅游经开区、大埠中心校气团光化学年龄较小,光化学反应活性相对较弱。VOCs对O3生成潜势最大的为芳香烃(93.81%),其次是烷烃(7.22%)和烯烃(4.75%);对SOA生成潜势最大的为芳香烃(97.45%),其次是烷烃(2.55%)。     

郑州市PM2.5组分季节性特征及来源研究

为了探究郑州市大气PM_(2.5)组分的季节性特征及来源,于2017年12月至2018年11月对郑州市5个点位进行采样,共采集有效环境受体样本1 166个。通过研究受体样本PM_(2.5)中的碳组分、水溶性离子和无机元素信息,获取各组分的季节特征,并结合正定矩阵因子分解(PMF)模型进行来源解析。结果表明,采样期间,郑州市PM_(2.5)平均浓度为69.6μg/m~3,占比较高的化学组分为NO_3~-、有机碳(OC)、SO_4~(2-)和NH_4~+,占比之和为86.7%。其中,NO_3~-、OC和NH_4~+呈现冬季高、夏季低的季节性浓度分布规律,SO_4~(2-)则是秋冬季稍高于春夏季。此外,Al、Si、Fe和Ca的浓度在春秋季略高于冬夏季。PMF模型解析结果显示,二次源为郑州市PM_(2.5)首要污染源,分担率为50.9%,其次是移动源(分担率12.0%)、燃煤源(分担率11.4%)和扬尘源(分担率10.2%)。其中,燃煤源在冬季较高、夏季较低,移动源在夏季最高,扬尘源在春季和秋季较高。     

石化装置安全仪表系统KooN表决结构的误跳车率定量分析

为了更准确量化安全仪表系统的误跳车率，基于联锁回路SIF中传感器、逻辑解算器、执行机构引发误跳车的不同失效机理和模型，考虑共因失效对误跳车率的影响，提出1种更符合实际并适用于异型KooN结构的新子系统误跳车率计算模型（STR of Non-identical Redundant System，SNRS）。针对SIF回路的误跳车率计算，建立了1种分析安全联锁SIF回路误跳车率（Reliability based Spurious Trip，RST）的计算框架。研究结果表明:以某聚丙烯装置第三反应器保护系统为例，将SNRS和RST方法与目前主流的多种计算方法进行数值计算对比，验证了方法的有效性，能够有效进行定量分析。     

Occurrence of selected aliphatic amines in source water of major cities in China

The formation of toxic nitrogenous disinfection byproducts (N-DBPs), such as nitrosamines, halonitromethanes and haloacetonitriles, from reactions between chlorine/chloramine and dissolved organic nitrogen in drinking water has caused great concern with regarding public health. This study revealed the occurrence of 17 aliphatic amines, some of which have been confirmed to be the precursors of N-DBPs, in source water across China. A sensitive method based on benzenesulfonyl chloride derivatization and liquid-liquid extraction followed by GC-MS analysis was established for the simultaneous analysis of the selected amines in aqueous samples. In total, 37 source water samples from the capital cities of 20 provinces were collected for the survey. Among the 17 amines, 14 were detected with an average frequency of detection of 36%. The most relevant amines in terms of frequency and maximum concentrations detected were dimethylamine (100%, 24.82 μg/L), methylamine (78%, 0.92 μg/L), N-methylethylamine (70%, 8.84 μg/L), propylamine (59%, 10.69 μg/L), diethylamine (54%, 3.76 μg/L), N-methylbutylamine (35%, 3.07 μg/L), N-ethylpropylamine (35%, 0.52 μg/L), and piperidine (32%, 2.35 μg/L). This is the first large scale survey of the aliphatic amines occurrence in source water in the world. The wide presence of nitrosamine precursors like dimethylamine, N-methylethylamine and diethylamine, and the precursors of haloacetonitriles and halonitromethanes like methylamine and propylamine suggests that better source water management is required to ensure the safety of drinking water.     

真空吸尘系统应用于散货码头的积尘清扫

描述了散货码头粉尘污染现状,分析比较了几种常用的积尘清扫方法。为了有效清扫散货码头的积尘,提出采用集中式真空吸尘系统。文章从系统形式、水力计算方法和工程实例等方面简单介绍了集中式真空吸尘系统。印尼Paiton燃煤电厂码头工程设计采用了集中式真空吸尘系统进行积尘清扫,工程建成投产一年多来,积尘清扫效果明显,有效地降低了粉尘污染。实例说明,真空吸尘是解决散货码头积尘清扫问题较为有效的方式。     

Synthesis, characterization and experimental investigation of Cu-BTC as CO2 adsorbent from flue gas

Porous Cu-BTC material was synthesized by the solvothermal method. Powder X-ray diffraction (PXRD) was used to test the phase purity of the synthesized material and investigate its structural stability under the influence of flue gas components. The thermal stability of the material was determined through thermal gravimetric (TG) analysis. Scanning electron microscopy (SEM) was employed to study the microstructure of the material. Cu-BTC was demonstrated not only to have high CO₂ adsorption capacity but also good selectivity of CO₂ over N₂ by means of packed bed tests. The adsorption capacity of Cu-BTC for CO₂ was about 69 mL/g at 22°C. The influence of the main flue gas components on the CO₂ capacity of the material were discussed as well.     

鼎湖山秋季大气细粒子及其二次无机组分的污染特征及来源

利用大气颗粒物质量浓度分析仪（TEOM）及大气细粒子快速捕集及其化学成分自动在线分析系统（RCFP-IC）于2008年10～11月在中国科学院华南植物园鼎湖山定位站进行了大气细粒子（PM2.5）及其二次无机组分（SO42-、NH 4＋和NO 3-）与相关污染气体组分的同步观测与分析,同时结合主成分分析和HYSPLIT轨...     

植物释放挥发性有机物(BVOC)向二次有机气溶胶(SOA)转化机制研究

利用自制玻璃生态罩,研究植物挥发性有机物（BVOC）的释放机制.在紫外光诱导条件下,BVOC经历一系列的光氧化反应,最终产生了二次有机气溶胶（SOA）.运用固相微萃取（SPME）和气相色谱-质谱联用（GC-MS）技术,对目标植物（驱蚊草）释放出的BVOC进行采样分析,共检测出7种主要化合物,其中主要为单萜类、倍半萜类、醇类和酮类物质.研究发现,在紫外光的照射下,这些BVOC可以发生光氧化反应转化为SOA.利用串联差分淌度分析仪（TDMA）测定SOA的粒径分布和SOA颗粒物的吸湿性.结果表明粒径范围大致是50～320 nm,吸湿性研究发现这些SOA具有吸湿性,生长因子可以从1.05增长到1.11.     

区域空气质量模拟中查表法的应用研究

在自行开发完善的区域空气质量模式系统RegSRRMS中应用查表法,模拟中国典型城市群对流层大气主要污染物的浓度变化,评估该方法在大气复合污染事件预测和控制中的有效性.首先,利用具有国际先进水平的空气质量模式WRF-CHEM中的化学模块建立了包含完善气相化学、气溶胶过程的箱模式WRFBOX.其次,利用WRFBOX进行化学反应敏感性分析,基于影响污染物的重要因子分别建立了臭氧(O3)及其前体物、无机盐气溶胶和二次有机气溶胶(SOA)查算表数据库,并检验其有效性.最后,将此查算表数据库引入RegSRRMS,建立简化的查表算法.利用直接耦合机制法和查表法对2000年3月珠三角地区污染个例中主要大气污染物浓度进行模拟.通过比较2种方法的模拟结果,显示查表法计算效率提高了57%,能够反映大气光化学反应的非线性特征、气溶胶及其前体物的平衡关系,具有高分辨率、高时效性,能够方便快捷地给出源和受体之间的响应关系,结果可靠.在区域空气质量模式中应用查表法有利于大气污染事件的快速预测以及大气污染控制的快速决策.     

Characteristics of contaminants in water and sediment of a constructed wetland treating piggery wastewater effluent

Constructed wetland (CW) is the preferred means of controlling water quality because of its natural treatment mechanisms and function as a secondary or tertiary treatment unit. CW is increasingly applied in Korea for secondary effluent of livestock wastewater treatment. This study was conducted to recognize the characteristics of contaminants in the accumulated sediment at the bottom soil layer and to reduce the phosphorus release from sediments of the free water surface CW for the treatment of secondary piggery wastewater effluent from a livestock wastewater treatment facility. The results revealed that the dominant phosphorus existence types at near the inlet of the CW were non-apatite phosphorus (59%) and residual phosphorus (32%) suggesting that most of the particles of the influent are made up of inorganic materials and dead cells. Sediment accumulation is important when determining the long-term maintenance requirements over the lifetime of CW. Continuous monitoring will be performed for a further assessment of the CW system and design.